Base oil | Viscosity at 40°C (mm2/s) |
Flash point (°C) | Copper Strip Corrosion Test | CI | AW/EP | Steel | Stainless steel hard metals | Alu | Copper alloys | Main uses | |
Chlorine-free range | |||||||||||
OLTEC Draw 32 SNA | mineral / vegetable | 32 | > 180 | 1b | no | ** | Cutting, drawing and punching of ferrous and non-ferrous metals. Wire drawing of aluminium wires. Thread forming | ||||
OLTEC Draw 60 SNA | vegetable | 60 | > 110 | 1b | no | * | |||||
OLTEC Draw S 46 | mineral | 46 | > 110 | 4c | no | ** | Difficult cutting and drawing of steel, including alloy and high-alloy steel. Cold heading, drawing, extrusion and rolling. Cutting and drawing on medium and thick sheet metals. Substitute for chlorinated neat oils for difficult drawing operations. Fine cutting of hard carbon steels and deep drawing operations | ||||
OLTEC Draw S 50 | mineral | 66 | > 110 | 4c | no | ** | |||||
OLTEC Draw 90 CF | vegetable | 90 | > 110 | 4c | no | ** | |||||
OLTEC Draw 210 | mineral | 210 | > 200 | 4c | no | *** | |||||
OLTEC Draw 420 | mineral | 420 | > 190 | 4c | no | *** | |||||
Chlorinated range | |||||||||||
OLTEC Draw V 031 | semi-synt. | 31 | > 200 | 1b | yes | **** | Very difficult cutting and drawing of steel, including alloy and stainless steel. Deep drawing, drawing, cambering and thread forming. Can be used as an additive (10%) to enhance drawing oils | ||||
OLTEC Draw V 033 | semi-synt. | 110 | > 200 | 1b | yes | **** | |||||
OLTEC Draw V 036 | synth. | 550 | > 200 | 1b | yes | **** |
: Recommended use
: Potential use
Gef Industrie 10.01.2024
Download range information